ET CPU-controlled Auto Booster Silent Pump(No Rust)-New Launch 2020/01

FEATURES:

  • Built-in microchip control. Automatic power off when no water is detected within 60 seconds, to avoid the motor being burn up.
  • Dual-voltage 110 / 220V design, you can adjust the required voltage.
  • Low operation noise. The supply of water pressure is stable, and the water pressure will not change suddenly when taking a hot bath. The water temperature will not suddenly become cold or hot.
  • All-in-one design, compact size saves installation space.
  • The pump casing structure is made of reinforced plastic steel, and the wetted parts are not rust or create rust water. The motor shaft also will not get stuck easily due to leave unused for a long time.
  • Built-in thermal switch, mainly to avoid frequent ON/OFF or nonstop running which lead to outlet pipeline to burst out by water overheating.
  • If the pump is installed outdoors, it is recommended to install a cover for protection. It can protect electronic parts in the ET series being damaged by heavy rain or direct sunlight which can extend the product life span.


Production & Assembly Line of ET pump in EVERGUSH Headquarters,Kaohsiung Taiwan.  All ET pumps are 100% strictly inspected and tested.

Production & Assembly Line of ET pump in EVERGUSH Headquarters,Kaohsiung Taiwan.  All ET pumps are 100% strictly inspected and tested.


APPLICATIONS:

  • Auto boost water pressure to the house, apartment, villa,school, restaurant, school, beauty shop,...etc.
  • Auto boost water pressure to garden sprinkler, heater,toilet, washing machine, sanitary equipment,...etc.

Auto boost water pressure to the house, apartment, villa,school, restaurant, school, beauty shop,...etc. Auto boost water pressure to garden sprinkler, heater,toilet, washing machine, sanitary equipment,...etc.


INSTALLATION 1:


INSTALLATION 2:


WORKING CONDITIONS:

  • Ambient Temp.: Max.40℃
  • Liquid Temp.: 0~40℃.
  • Relative humidity: Max.85%(RH).
  • Working pressure: Max. 5 bar.
  • Before starting the pump, make sure that the inlet water pressure cannot be greater than pre-set activation pressure from the factory.
  • Applicable liquids: drinking water or other liquids that are not corrosive and have characteristics close to clean water.
  • Not suitable for pumping groundwater or hot water which is over 40℃.

SPECIFICATION:

  • Output: 1/4HP(180W);1/2HP(380W) 
  • Motor Protection: IP54
  • Motor Insulation: E class.
  • Enclosed Fan-cooled 2P Induction Motor.Built-in Motor Overload Protector.
  • Voltage: Single phase110/220V(Dual-voltage)*60Hz ; 220~240V*50Hz(Customized)
  • Inlet/Outlet: 3/4” or 1”
  • Pre-set Activation Pressure: ET200:1.2 bar.  ET400: 1.6 bar.  
  • Standard Performance for 60Hz Model: ET200:15M*30LPM ; ET400: 20M*30LPM 
  • Standard Performance for 50Hz Model: ET200:15M*36LPM ; ET400: 20M*40LPM
Any questions about our products?

The EVERGUSH branch offices cover all round Taiwan. If you have any questions about our products or need related technical data, please feel free to contact with EVERGUSH local branch office. Please link our branch office as following.

Equipment failure? Try our online troubleshooting.
Right here we will provide solutions for problems or failures that you could've encountered with pumps. The content of these solutions have been gathered from experienced and professional technicians in our company. Before you contact our technicians for answers, we suggest you read through below basic troubleshooting and instruction manual. It should help you to understand more about our products, and also find out the solutions more quickly.