FEATURES:
- The pump casing structure is made of heat-resistant reinforced plastic steel, and the wetted parts are not rusty. The motor shaft also will not get stuck easily due to leave unused for a long time.
- Built-in microchip control. Automatic power off when no water is detected within 60 seconds, to avoid the motor being burnout.
- Dual-voltage 110 / 220V design(Only for 60Hz), you can manually adjust the required voltage.
- Low operation noise. The supply of water pressure is stable, and the water pressure will not change suddenly when taking a hot bath. The water temperature will not suddenly become cold or hot.
- All-in-one design, compact size saves installation space.
- If the pump is installed outdoors, it is recommended to install a protective cover on the ETH pump. It can protect the pump and electronic components from heavy rain, wind and direct sunburn, to extend product life.
Production & Assembly Line of ET and ETH pump in EVERGUSH Headquarters,Kaohsiung Taiwan. All ET and ETH pumps are 100% strictly inspected and tested.
APPLICATIONS:
- Auto boost water pressure to the house, apartment, villa,school, restaurant, school, beauty shop,...etc.
- Auto boost water pressure to garden sprinkler, heater,toilet, washing machine, sanitary equipment,...etc.
- Hot water pressure boosting from solar heater.
The installation for ET and ETH pump are the same. The main difference is ETH can be used for <80℃ hot water. The ET pump can only use for <40℃ normal water.
INSTALLATION 1:
INSTALLATION 2:
WORKING CONDITIONS:
- Ambient Temp.: Max.45℃
- Liquid Temp.: 2~80℃.
- Relative humidity: Max.85%(RH).
- Working pressure: Max. 5 bar.
- Before starting the pump, make sure that the inlet water pressure cannot be greater than pre-set activation pressure from the factory.
- Applicable liquids: drinking water or other liquids that are not corrosive and have characteristics close to clean water.
- Not suitable for pumping groundwater or hot water which is over 80℃.
SPECIFICATION:
- Output: 1/4HP(180W);1/2HP(380W)
- Motor Protection: IP54
- Motor Insulation: E class.
- Enclosed Fan-cooled 2P Induction Motor.Built-in Motor Overload Protector.
- Voltage: Single phase110/220V(Dual-voltage)*60Hz ; 220~240V*50Hz
- Inlet/Outlet: 3/4” or 1”
- Pre-set Activation Pressure: ETH200:1.2 bar. ETH400: 1.6 bar. ETH800: 2.0 bar.
- Standard Performance for 50Hz Model: ETH200:15M*30LPM ; ETH400: 20M*36LPM ; ETH800: 24M*52LPM
- Standard Performance for 60Hz Model: ETH200:15M*30LPM ; ETH400: 20M*30LPM ; ETH800: 25M*40LPM