- Stable water pressure while using hot shower.
- No water hammer, improve start/off frequency.
- Low noise and smooth operation. The system will adjust motor speed automatically, according to demand of capacity. It can save energy resources and uplift performance.
- Choose appropriate capacity of pressure tank, types of water pumps, quantities of inverter, and operation approach.
- Dry-running detection. It will turn off automatically once no water occurs to avoid motor burn out.
- No water tank, easy to install, reduce the cost of maintenance.
- Adopting high quality brand “DELTA” inverter, high efficiency, softly start/off functions.
- Alterative operation to extend life time of pumps.
- 2 Major installation ways- One is installed the pump system in the top floor or roof of the building, auto-boost water pressure downward whole building. Another is installed the pump system on the ground or basement, auto-boost water pressure to (upward) the building.(Please refer to below PIC.1~5)
Auto boost water pressure for IC manufacture industries, industrial pressure boosting systems, motels, restaurants, gas stations, apartments, factories, schools, parks, gymnasiums, villas, railway station, building sites, etc.
- Ambient Temperature: 0~+50℃
- Liquid Temperature: +0~+60℃
(If delivering water temperature is over 60 degree C, we strongly recommend to replace for heat-resistant "VITON" mechanical seal)
- Clean or potable water or no corrosive chemicals liquids without abrasives.
- Working Pressure: Max. 5~20bar.(depending on pumps)
- Power: 1/2HP~20HP (Special Output requirement is available upon customer's request.)
- Protection: IP54~IP55
- Protection: E,B,F
- Pole: 2P,4P
- Voltage: 1phase 110;220V*60HZ(1HP~3HP); 3phase 220/380/440/660*60HZ
1phase 220~240V*50HZ(1HP~3HP); 3phase 380~415V*50HZ
- Suction/Discharge piping: 1” ~8”
- Head: Max. 260 M
- Capacity Range: 4~2160M³/hr.